Controller for GFG Touches
Important
We supply a suitable controller for almost every application.Below you will find a detailed technical documentation of our 5-wire Single Chip Ic controllers for our patented GFG ULTRA technology:
Basic description
Hardware Specification
- Package :MLP-28
- Package Dimension: 5 mm X 5 mm X 0.9 mm
- Supplied Voltage: 3.3 (2.7 ~ 3.6) VDC, 50 mVpp maximum ripple
- Power consumption: max. 75 mA
- Max. report rate: 200 pps(RS232)/250 pps(USB)
- Response time: max. 25 ms
- A/D resolution: 11 bits
- Good package: Tube
Firmware Specification
The C8051F321-GM microprocessor is applied for the controller module. The firmware in this chip controls the Touch down detection, button status Detection.
The firmware characteristics
- Operation System: No operation system is required
- Protocol: RS232 8N1, 9600 baud/USB 1.1 Low Speed/USB 2.0 Full Speed/ PS2 compatible mouse
- Data package format: the protocols can be classified into 2 groups: Diagnostics Packet and Report Packet
Analog Peripherals
High-Speed 8051 uC Core
- Pipelined instruction architecture; executes 70% of instructions in 1 or 2 system clocks
- Up to 25 MIPS throughput with 25 MHz Clock
- Expanded interrupt handler Memory
- 1280 bytes data RAM
- 16 kB Flash; in-system programmable in 512-byte sectors (512 bytes are reserved)
Digital Peripherals
- 21 port I/O; all are 5 V tolerant
- Hardware SMBus™ (I2C™ compatible), SPI™, and UART serial ports available concurrently
- Programmable 16-bit counter/timer array with five capture/compare modules
- 4 general-purpose 16-bit counter/timers Clock Sources
- Internal oscillator: 0.25% accuracy with clock recovery enabled; supports all USB and UART modes
- External oscillator: Crystal, RC, C, or Clock
- On-chip clock multiplier for USB controller
Voltage Regulator
- On-chip voltage regulator supports USB bus-powered operation
- Regulator bypass mode supports USB self-powered operation Package
- 28-pin QFN (lead-free package)